S2K Commerce - Products Dropdown

Actions
Loading...

S2K Commerce - Shopping Cart

Actions
Loading...

S2K Commerce - Order Entry

Actions
Loading...
Home  >  Resins, Polyester & Vinylester & Epoxy  > Table Top_Commercial_2Gl Kt

Table Top_Commercial_2Gl Kt 1:1 A&B Epoxy Kit in Gl Jugs

Item #:142658 
  Commercial Grade Table Top Epoxy is here for a Limited Time! Now only $84.95!
The Kit includes 1 gallon of A-side Base Resin and 1 Gallon of B-side Activator. Product is a 1:1 mix ratio by volume and dries to a clear, plastic finish. Perfect for counter tops, bar tops, tables, jewelry projects, wood working and so much more! 
 
84.95
Each
Quantity:
Quantity Price
1.0 84.95
142658
Incomplete and incorrect mixing are the most common causes of poor results—leaving uncured, tacky areas on your project. Too much activator will cause the resin to be soft and feel like rubber, too little activator and the resin will not cure properly. For best results, mix in one bucket then pour mixture into
second bucket and very thoroughly mix again. 
 
Directions for Use:
Step 1: The ideal working temperature is around 77°F. Best results can be obtained at temperatures between 70°F and 85°F, in a clean, dry, dust-free environment. Avoid working in high humidity. We recommend using this product on a leveled and flat work surface.
 
Step 2: Using the Laminate Coverage Chart, measure product in accordance with your intended use. Prepare 1 part Base Resin to 1 part Curing Agent by liquid volume or 100 parts Base Resin to 83 parts Curing Agent by weight. Pour the Curing Agent first and then the Base Resin into a clean, smooth-sided container large enough to hold all the liquid and allow room for mixing.
 
Step 3: The material must be mixed thoroughly for at least 3 minutes. Be sure to scrape the container sides, bottom, and corners as you mix. Be careful to not whip excessive air into the mixture. If mixing a gallon, use a power mixer set to “hand speed.” For smaller quantities, use stir sticks. Do not mix more than a gallon.
 
Step 4: Pour the mixed resin onto the surface and distribute evenly with a squeegee or gloved hand. Continue to pour remaining material to achieve the desired thickness, allowing the resin to flow evenly over the project’s sides.
 
Step 5: See Additional Information for guidance to help eliminate bubbles that have risen to the surface of the resin.
 
Step 6: If you are going to make a second pour, the first pour should still be lightly sticky. Once the second pour is made, bubbles may once again need to be removed. Material will feel well-cured after 24 hours, but full cure and maximum hardness can require up to 7 days depending upon the temperature.
Ground Shipping Only
Used to release air trapped near the surface of Table Top Epoxies.
Bust-A-Bubble, Air Release, Spray, 8 oz. Used to release air trapped near the surface of Table Top Epoxies.
2.91
Each
Heat Gun, 110 v, 700watt/1500watt, 12.5amp, 4 Nozzles; for softening
Heat Gun, 110 v, 700watt/1500watt, 12.5amp, 4 Nozzles; for softening and removing paint/varnish, thawing frozen metal pipes. Low heat setting 482 F. and high setting of 842 F
31.99
Each