STEP 1:

Using the Coverage Chart, determine the amount of epoxy you will need for your project. Lightly sand the surface of your substrate to assist in primer bonding and clean with Superclean or Isopropyl Alcohol (90% or higher). Apply tape to any areas that will not require priming and sealing.

STEP 2:

Ensure your working environment is clean, dry and at least 70 to 84 degrees for best results. Lay down a plastic sheeting below your project for a safe, easy cleanup. Make sure your surface is completely level, as the epoxy will self-level.

STEP 3:

Shake the A and B side jugs vigorously to agitate the product. If the material is not properly agitated, it may not cure properly. 

STEP 4:

Measure 2 parts Resin to 1 part Activator and pour into a clean, dry bucket or cup. Add 20-30% distilled water to the mixture. Stir the mixture for at least 5 minutes with a drill mixer set to low. Ensure you are not whipping air into your epoxy. Be sure to scrape the sides and bottom to ensure all of your epoxy is properly mixed. 

STEP 5:

Transfer contents to a new, clean, dry bucket or cup and continue mixing for 5 more minutes to ensure proper mixing, again scraping sides and bottom. 

STEP 6:

Apply a thin, even coating to the surface with a foam roller or paintbrush. Be careful not to apply too thick, or water blisters will form. 

STEP 7:

Allow the material to become hard and tacky to the touch before applying Superclear Countertop Epoxy.