Sign up today and receive a 10% off coupon for your next order!
"*" indicates required fields
Sign up today and receive a 10% off coupon for your next order!
"*" indicates required fields
– LIGHTWEIGHT & DURABLE LAMINATING EPOXY
– QUICK & EFFICIENT WORKING TIME
– 100% MADE IN THE USA
$54.99 – $149.99
FGCI Marine Grade Epoxy Laminating Resin is perfect for boat building, boat repair, laminating, and wet layups. The 3:1 mixture is especially formulated for a shorter working time and faster cure. This fiberglass laminating resin is extremely durable and built to last!
We have spent over 60 years perfecting our laminating epoxy formulation for use within the marine, construction, and auto industries. FGCI Marine Grade Laminating Epoxy is useful for repairing or creating lightweight and high-strength composite structures that will stand the test of time, even in the most severe environments.
Our 3:1 Lamination Epoxy makes boat building and boat repair a breeze! Issues like cracks, scrapes, gelcoat blistering, loose hardware, and delamination are no match for our easy-wet-out formulation.
Small part production just got easier – No need to wait overnight before pulling a mold thanks to our 3:1 FAST epoxy laminating resin. This marine grade epoxy resin is thin enough to make for an easy wet out on anything from 1708 to Fiberglass Cloth and even Carbon Fiber!
Be sure to only mix small amounts at a time, stirring for a full 3 minutes. At 77 degrees, the FGCI Marine Laminating Epoxy 3:1 – Fast Kit will take around 8-10 minutes to set up, with a full cure taking around 24 hours.
NOTE: Gelcoat does not stick to epoxy, while inversely epoxy does stick to gelcoat. So, if you’re planning on adding a layer of gelcoat to your epoxy lamination, then be sure to go with one of our Polyester blend resins.
PRO TIP: Laminating Chopped Strand Mat with epoxy is not recommended due to the binder in the fiberglass. For mat, use a Polyester resin for best results.
Directions
Step 1: Ensure your project is ready to laminate and is in a clean, level, dust-free environment. If pulling a part from a mold, ensure the mold is properly surfaced and waxed for easy pulls. Ideal working temperature is between 70-85 degrees, with warmer temperatures leading to less working time.
Step 2: Measure 3 parts A-side Laminating Epoxy to 1 part B-side Activator by volume.
*Note: ratio by weight is 100:31
Step 3: Mix the material thoroughly with a mixing stick for at least 3 minutes. Be sure to scrape the sides and bottom of the container as you mix.
Step 4: Apply the material liberally by either pouring onto your surface or spooning it with a clean paint brush.
Step 5: Work the material around the desired area thoroughly with a roller or a paint brush, ensuring equal amounts of resin to glass throughout.
Step 6: Allow material to fully cure before pulling your part. Full cure is approximately 24 hours.
Cleanup tools and work area with Isopropyl Alcohol immediately after use for best results.
Charlie Norris
Brian Lewis
Justin Lammers