Vinylester Vacuum Infusion Resin

Modified Infusion Resin

Modified Vinylester Infusion Resin makes using in a vacuum bagging or infusion setting easy with a thinner formula, longer cure time and hard laminate. This resin produces a solid, chemical-resistant finish and wets out very easily on fiberglass.

 

*Contact us through our Contacts page for Drum Quantities. 

$449.99

1 in stock

Modified Vinylester Infusion Resin

MVR8071 modified Vinylester infusion resin is a low viscosity resin specifically made to pull through a vacuum. The longer geltime of 45-53 minutes at 77 degrees makes this resin easy to fully disperse through a vacuumed part and fully soak in. The Vinylester/Polyester blend allows for a very durable surface that is highly chemical and temperature resistant.

Infusion Resin features

  • Low Viscosity
  • Low Exotherm/Shrinkage
  • Excellent wet-out of fiberglass
  • Great, durable cure
  • Improved Surface Quality
  • Rapid Filling of Parts
  • High Laminate physical properties

 

PLEASE NOTE: This information is provided in good faith and correct to the best of our knowledge. No warranty, guarantee, or representation is made as to the sufficiency of the information for the safe use of the product, nor to relieve the end user of any Federal, State, or Local regulatory responsibility. 

 

Catalyst Concentration Chart - Resins and Gelcoat
Be the first to review “Vinylester Vacuum Infusion Resin”

Your email address will not be published. Required fields are marked *